Oil boiler waste heat boiler scope of products: Due to the use of heating oil in comparison with the use of steam heating both uniform heating, simple operation, safety and environmental protection, energy saving, high precision, and low operating pressure, in modern industrial production has been widely used as a heat transfer medium. Oil boiler flue gas temperature is generally higher, both directly emitted into the air pollution and waste of energy. By installing oil boiler waste heat boiler can take full advantage of this part of the wasted energy. Equipment principle introduced: the efficient use of industrial fuel oil, gas, coal-fired boiler for about 70% of the waste heat in the flue gas accounted for most of the heat. Normally oil furnace flue gas temperature 250--350 degrees. Such high temperatures not only pollute the environment, but also waste a lot of fuel, increasing production costs. The product is the use of this part of the heat pipe heat recovery. Use to improve boiler feed water, blast temperature, or direct steam generation scour Heat Pipe end, the heat pipe working fluid evaporates into a gas flow to the cooling side, cooling side condensing heat, water or air is heated to produce hot water hot air and steam. Equipment advantages and features: 1, high security and reliability: the conventional heat transfer equipment are generally partitions heat, hot and cold fluid on each side wall of the flow, such as a wall or walls have leaked, it will result in shutdown loss. Heat pipe heat recovery device is a secondary heat exchanger partition that you want to spread heat Ling fluid through the heat pipe evaporator and condenser section of wall to wall. 2, heat pipe heat recovery unit high heat transfer efficiency, energy-saving effect is remarkable. 3, the heat pipe heat recovery device has a good corrosion resistance of the heat pipe wall temperature can be adjusted, can be converted to heat by a suitable heat pipe wall temperature adjusted cryogenic fluid above the dew point, so as to prevent dew point corrosion, ensure long-term device run. Due to the dew point to avoid the smoke, so that dust is not easy to bond on the ribs and the wall. At the same time will produce heat pipe thermal self-vibration, the ash is not easy to stick to the wall and fins, and thus will not block ash. 4, installation and structural layout flexibility: heat pipe heat recovery device is installed without changing the original process systems, structural design and location of the layout is very flexible and can adapt to a variety of complex applications. 5, small: just 6 1/3 ordinary heat exchanger, long life: the life of more than 10 years, a single removable heat pipe replacement, simple and low maintenance costs. 7, the payback period is short: usually six months to a year all the investment can be recovered.